Operation Manual
Table Of Contents
- INDEX
- Front cover
- Important Information
- Table of Contents
- 1. Introduction
- 2. Installation and Connections
- 3. Projecting an Image (Basic Operation)
- 4. Convenient Features
- (1) Turning Off the Image and Sound
- (2) Freezing a Picture
- (3) Enlarging and Moving a Picture
- (4) Changing Lamp Mode
- (5) Getting Integrated Help
- (6) Using a USB Mouse
- (7) Using the Optional Remote Mouse Receiver (NP01MR)
- (8) Correcting Horizontal and Vertical Keystone Distortion [CORNERSTONE]
- (9) Displaying Two Pictures at the Same Time
- (10) Preventing Unauthorized Use of the Projector
- (11) Limiting Access Level to Available Menu Items
- (12) Operation Using an HTTP Browser
- (13) Projecting Your Computer’s Screen Image from the Projector via a Network [NETWORK PROJECTOR]
- (14) Using the Projector to Operate Your Computer via a Network [REMOTE DESKTOP]
- 5. Using the Viewer
- 6. Using On-Screen Menu
- 7. Maintenance
- 8. Using Optional Lenses
- 9. Appendix
- (1) Troubleshooting
- (2) Specifications
- (3) Cabinet Dimensions
- (4) Screen Size and Projection Distance
- (5) Pin Assignments of D-Sub COMPUTER 1 Input Connector
- (6) Compatible Input Signal List
- (7) PC Control Codes and Cable Connection
- (8) Removing and Attaching the USB Wireless LAN Unit
- (9) Troubleshooting Check List
- (10) TravelCare Guide
22
2. Installation and Connections
Connecting the Supplied Power Cable
Connect the supplied power cable to the projector.
First connect the supplied power cable’s three-pin plug to the AC IN of the projector, and then connect the other
plug of the supplied power cable in the wall outlet.
LAM
P
STATUS
POWER
O
N
/
S
T
A
N
D
B
Y
SOU
RCE
AUTO ADJUST
3
D REFORM
S
E
L
E
C
T
USB
LENS SHIFT
LEFT
RIGHT
DOWN
U
P
WIRELESS
WIRELESS
Make sure that the prongs are fully
inserted into both the AC IN and the
wall outlet.
To wall outlet
L
EN
S
S
HIF
T
LEF
T
TIP: To turn off the AC power supply when the projector is powered on, use a power strip equipped with a switch and a breaker.
CAUTION:
Do not try to touch the ventilation outlet on the left front (when seen from the front) as it can become heated
while the projector is turned on and immediately after the projector is turned off.
CAUTION:
Do not unplug the power cable from the wall outlet or projector when the projector is powered on. Doing so can
cause damage to the AC IN connector of the projector and (or) the prong plug of the power cable.
About Direct Power Off
The projector has a feature called “Direct Power Off”. This feature allows the projector to be turned off (even when
projecting an image) using a power strip equipped with a switch and a breaker.
NOTE: Before using Direct Power Off, be sure to allow at least 20 minutes immediately after turning on the projector and starting
to display an image.