Operation Manual
Table Of Contents
- INDEX
- Front cover
- Important Information
- Table of Contents
- 1. Introduction
- 2. Installation and Connections
- 3. Projecting an Image (Basic Operation)
- 4. Convenient Features
- (1) Turning Off the Image and Sound
- (2) Freezing a Picture
- (3) Enlarging and Moving a Picture
- (4) Changing Lamp Mode
- (5) Getting Integrated Help
- (6) Using a USB Mouse
- (7) Using the Optional Remote Mouse Receiver (NP01MR)
- (8) Correcting Horizontal and Vertical Keystone Distortion [CORNERSTONE]
- (9) Displaying Two Pictures at the Same Time
- (10) Preventing Unauthorized Use of the Projector
- (11) Limiting Access Level to Available Menu Items
- (12) Operation Using an HTTP Browser
- (13) Projecting Your Computer’s Screen Image from the Projector via a Network [NETWORK PROJECTOR]
- (14) Using the Projector to Operate Your Computer via a Network [REMOTE DESKTOP]
- 5. Using the Viewer
- 6. Using On-Screen Menu
- 7. Maintenance
- 8. Using Optional Lenses
- 9. Appendix
- (1) Troubleshooting
- (2) Specifications
- (3) Cabinet Dimensions
- (4) Screen Size and Projection Distance
- (5) Pin Assignments of D-Sub COMPUTER 1 Input Connector
- (6) Compatible Input Signal List
- (7) PC Control Codes and Cable Connection
- (8) Removing and Attaching the USB Wireless LAN Unit
- (9) Troubleshooting Check List
- (10) TravelCare Guide
40
Correcting Horizontal and Vertical Keystone Distortion [COR-
NERSTONE]
Use the 3D Reform feature to correct keystone (trapezoidal) distortion to make the top or bottom and the left or right
side of the screen longer or shorter so that the projected image is rectangular.
4. Convenient Features
Projected image
Cornerstone
1. Press and hold the 3D REFORM button for a minimum of 2 seconds to reset current adjustments.
Current adjustments for [KEYSTONE
] or [CORNERSTONE] will be cleared.
2. Project an image so that the screen is smaller than the area of the raster.
3. Pick up any one of the corners and align the corner of the image with a corner of the screen.
The drawing shows the up-
per right corner.
4. Press the 3D REFORM button twice.
The Cornerstone adjustment screen is displayed.
5. Use the SELECT
button to select one icon (
) which points in the direction you wish to move the
projected image frame.
6. Press the ENTER button.
Screen
TIP: If you are adjusting [KEYSTONE], [CORNERSTONE] will not be
available. If this happens, press and hold the 3D REFORM button for a
minimum of 2 seconds to reset the [KEYSTONE] adjustments.
The drawing shows the upper left
icon (
) is selected.
TIP:
NP3150/NP2150/NP1150: When [WIDE SCREEN] is selected from
[SCREEN TYPE], lines that show “16:9” will be displayed. Click the
outer corners.
NP3151W: When [4:3 SCREEN] is selected from [SCREEN TYPE],
lines that show “4:3” will be displayed. Click the outer corners.