User Manual

47
4. Using the Viewer
Removing the USB memory from the projector
1. SelecttheVIEWERstartscreen.
 PresstheEXITbuttonwithnomenudisplayed.
2. Remove the USB memory from the projector.
Make sure that the LED on the USB memory is not flashing
before removing the USB memory.
NOTE: If you remove the USB memoryfrom the projector with a slide
displayed,theprojectormaynotoperatecorrectly.Ifthishappens,turn
offtheprojectorandunplugthepowercord.Wait3minutes,thenconnect
thepowercord,andturnontheprojector.
Exiting the Viewer
1. Press the MENU button with the slide screen or the
thumbnail screen displayed.
The control bar or the pop-up menu will be displayed.
2. Press the MENU button again.
The on-screen menu will be displayed.
3. Select a source other than [USB-A] and press the
ENTER button.
The Viewer will be exited.
TIP:ToexittheViewerusingthe remotecontrol, selectasource other
than[USB-A].