User's Manual

199

9. Appendix

 Mounting the cable cover (sold separately)

Mounting the separatelysold cable cover on the projector allowsyou hide the cablesfor a cleaner

appearance.

CAUTION

• Aftermountingthecablecover,besuretofastenusingthescrewsprovided.Ifnot,thecablecovercouldfall,

damagingthecablecoverandpossiblyresultingininjury.

• Donotbundlethepowercordandplaceitunderthecablecover.Doingsocouldleadtore.

• Donotapplyexcessiveforcetothecablecover.Doingsocoulddamagethecablecover,resultinginthe

projectorfallingorcausinginjury.

Mounting

Preparations:

1. Connect the power cord and cables to the projector (the connection cords are omitted from the diagrams).

2. Prepare a Phillips screwdriver.

1. Insert the two round protrusions on the left and right edges

of the cable cover into the grooves in the bottom of the

projector to line it up.

NOTE:Becarefulnottoletthepowercordandcablesgetpinchedbythe

cablecover.

2. Turn the cable cover screw clockwise.

- Tighten the screw securely.

Removing

1. Turn the cable cover screw counterclockwise until it turns

loosely.

- Hold the cable cover while doing this to prevent it from

falling.

- The screw does not come completely off.

2. Remove the cable cover.

- Turn the cable cover a little, then lift it off.