User's Manual

2. Projecting an Image (Basic Operation)

 Connecting Your Computer/Connecting the Power Cord

1. Connectyourcomputertotheprojector.

This section will show you a basic connection to a computer. For information about other connections, see “(2)

Making Connections” on page 143.

Connect the computer cable (VGA) between the projector’s COMPUTER IN connector and the computer’s port

(mini D-Sub 15 Pin). Turn two thumb screws of both connectors to ﬁx the computer cable (VGA).

2. Connectthesuppliedpowercordtotheprojector.

First connect the supplied power cord’s three-pin plug to the AC IN of the projector, and then connect the other

plug of the supplied power cord in the wall outlet.

The projector’s power indicator will light orange* (standby mode).

The STATUS indicator will also light green*.

* This will apply for both indicators when [NORMAL] is selected for [STANDBY MODE]. See the Power Indicator

section.(→ page 214)

COMPUTER IN

Make sure that the prongs are fully inserted into

both the AC IN and the wall outlet.

To wall outlet

CAUTION:

PartsoftheprojectormaybecometemporarilyheatediftheprojectoristurnedoffwiththePOWERbuttonorifthe

ACpowersupplyisdisconnectedduringnormalprojectoroperation.

Usecautionwhenpickinguptheprojector.