User's Manual

HID : Human Interface Device
Connector Specifications
1 VBUS (Power supply)
2 D- (- Signal)
3 D+ (+ Signal)
4 GND (Ground)
* Depending on the USB host controller in the personal computer, the USB connection may fail to operate. When
using a USB hub, please use a self-powered type, not a bus-powered type. When using a USB hub, connection to
the first stage of the USB hub is recommended.
LAN connection
----------------------------------------------------------------------
[ Wired LAN port ]
LAN interface
Communication speed: Auto setting (10/100Mbps)
Certified standard: IEEE802.3 (10BASE-T)
IEEE802.3u (100BASE-TX, Auto-Negotiation)
A LAN connector (8 male RJ-45 connector)
1 TD+ Transmit data (+)
2 TD- Transmit data (-)
3 RD+ Receive data (+)
4 Not used
5 Not used
6 RD- Receive data (-)
7 Not used
8 Not used
[ Wired/wireless LAN card ]
The LAN connections will differ depending on the commercial LAN card that is used.
- For information on supported LAN cards, visit:
Global: http://www.nec-pj.com/
[Port Number]
The TCP port number used is "7142".
====================================================================
4. List of Commands
----------------------------------------------------------------------
* Example for command
----------------------------------------------------------------------
Command name Example
----------------------------------------------------------------------
006. RUNNING SENSE 00H 81H 00H 00H 00H 81H
007. COMMON DATA REQUEST 00H C0H 00H 00H 00H C0H
009. ERROR STATUS REQUEST 00H 88H 00H 00H 00H 88H
015. POWER ON 02H 00H 00H 00H 00H 02H
016. POWER OFF 02H 01H 00H 00H 00H 03H
018. INPUT SW CHANGE 02H 03H 00H 00H 02H <DATA> CKS
020. PICTURE MUTE ON 02H 10H 00H 00H 00H 12H
021. PICTURE MUTE OFF 02H 11H 00H 00H 00H 13H