User's Manual

2) Punch in DATA06 DATA05 DATA04 DATA03 (00004650)
3) Change from HEX to Decimal - value will change to 18000 seconds
Lamp's use of hours = 18000/3600 = 5 hours
* In case of acquiring the remaining time until lamp warning message starts to appear (in terms of specified
values)
03H 96H 00H 00H 02H 00H 08H A3H
Example of acquisition
DATA03 DATA04 DATA05 DATA06: Remaining time
40H 7EH 05H 00H: 360000 seconds
Calculator Procedure
1) Set calculator to HEX
2) Punch in DATA06 DATA05 DATA04 DATA03 (00057E40)
3) Change from HEX to Decimal - value will change to 360000 seconds
Remaining time until lamp warning message starts to appear
= 360000/ 3600= 100 hours
(!) Lamp Hour Meter
This is the timer for normal lamp mode conversion.
(!!) Lamp usage time
This is the lamp total usage. It is displayed in the projector's menu.
(!!!) NP4000/4001, NP4100/4100W : This function is not supported.
037.6. CARBON SAVINGS INFORMATION REQUEST
**********************************************************************
Function:
This command acquires the Carbon Saving values on the projector.
Command:
03H 9AH 00H 00H 01H DATA01 CKS
(*3)
Data Portion Contents
-------------------------------------------------------------------
DATA01 Acquirement items
00H : Total Carbon Savings
01H : Carbon Savings during operation
Response: At the time of a success
23H 9AH 01H xxH 09H DATA01 to DATA09 CKS
(*1) (*2) (*3)
Data Portion Contents
-------------------------------------------------------------------
DATA01 Same as DATA01 of the transmit data
DATA02 to 05 Carbon Savings (Kilogram Maximum: 99999[kg])
DATA06 to 09 Carbon Savings (Milligram Maximum:999999[mg])
Response: At the time of a failure
A3H 9AH 01H xxH 02H DATA01 DATA02 CKS
(*1) (*2) (*4) (*3)
Supplement:
Example for Total Carbon Savings
DATA02 DATA03 DATA04 DATA05 : Kilogram
9CH 09H 00H 00H : 2460 [kg]