User's Manual

* A USB cable is supplied as standard with the MT860/1060/1065/1075.
* The GT5000/6000 does not come with a USB cable.
* Note that a connection method using the supplied USB cable is not supported for the LT220/240/260.
* The serial cable, LAN card and LAN cable are separately sold.
* The WT610 replaced the WT610 and uses the same command set.
(CAUTION)
Before making connections, be sure to invalidate the standby mode of the projector and set the "idle mode". The
projector cannot use the control commands in the standby mode.
Setting method: Under projector [Projector Options] --> [Setup], enter a check for [Idle Mode] on Page 4.
( CAUTION ) (!1)
Before making connections, be sure to select [NORMAL] for [STANDBY MODE].
Setting method : From the projector's menu, select [SETUP] --> [OPTIONS(2)] -->[STANDBY MODE]--> [NORMAL].
( CAUTION ) (!2)
The projector accept the "POWER ON" command during [POWER-SAVING] mode for[STANDBY MODE].
Supplement:
(!1) Only the NP600/NP610/NP3200 series is compatible.
(!2) Only the M300 series is compatible.
[P350X/P350W/P420X Series]
STANDBY MODE: "POWER-
SAVING"
Control Command
Serial
port
Wired
LAN
port
Wireless
LAN
unit
POWER ON
Yes
No
No
Yes: Supported
No: Not supported
[P401W/P451W/P451W/P501X
Series]
[PA600X/PA550W/PA500U/PA500X Series]
[PX700W/PX750U/PX800X Series]
[PH1000U Series]
STANDBY MODE: "POWER-
SAVING"
Control Command
Serial
port
Wired
LAN
port
Wireless
LAN
unit
POWER ON
Yes
No
No
STANDBY MODE: "NETWORK STANDBY"
Control Command
Serial
port
Wired
LAN
port
Wireless
LAN
unit
POWER ON
Yes
Yes
Yes
Yes: Supported
No: Not supported