Operation Manual

126
5. Using On-Screen Menu
[OPTIONS(1)]
Setting Auto Adjust [AUTO ADJUST]
ThisfeaturesetstheAutoAdjustmodesothatthecomputersignalcanbeautomaticallyormanuallyadjustedfor
noiseandstability.Youcanautomaticallymakeadjustmentintwoways:[NORMAL]and[FINE].
OFF ������������������������ The computer signal will not be automatically adjusted� You can manually optimize the computer signal�
NORMAL ���������������� Default setting� The computer signal will be automatically adjusted� Normally select this option�
FINE ����������������������� Select this option if fine adjustment is needed� It takes more time to switch to the source than when [NOR-
MAL]is selected�
Selecting Fan Mode [FAN MODE]
FanModeisusedtosetthespeedoftheinternalcoolingfan.
MODE �������������������� Select three modes for fan speed: AUTO, HIGH, and HIGH ALTITUDE�
AUTO: The built-in fans automatically run at a variable speed according to the internal temperature�
HIGH: The built-in fans run at high speed
HIGH ALTITUDE: The built-in fans run at a high speed� Select this option when using the projector at altitudes
approximately5500feet/1600metersorhigher.
SETTING ���������������� Select one of the four options ([FLOOR], [CEILING], [VERTICAL TILT DOWN], or [VERTICAL TILT UP])
according to the installation angle of the projector� See the drawing below�
NOTE:Besuretoselectthe[SETTING]optionaccordingtotheprojector’sorientation.Failuretodosomay
cause product malfunction.
0°
70°
90°
250°
180°
110°
270°
290°
Select [VERTICAL TILT UP] for this angle
Select [VERTICAL TILT DOWN] for this angle
Select [FLOOR] for this angle
Select [CEILING] for this angle
Whenyouwishtocooldownthetemperatureinsidetheprojectorquickly,select[HIGH].