Operation Manual

175
6. Installation and Connections
AttachingStackingHolders
Attachthreestackingholderstothreelocationsonthetopofthelowerprojector.
Preparation:
ToolsrequiredarePhillipsscrewdriver(plus-head)andthreestackingholderspackagedwiththeprojector.
Loosenthetiltfeet(threelocations)oftheprojector.
1. Removerubbercapsandscrewsatthreelocations.
(1) Use your tweezers or nail to pinch and pull up the rubber cap.
(2) Remove the screw from a square hole.
(1) (2)
2. Attachthethreestackingholdersatthreelocations.
(1) Place a stacking holder in a square hole.
(2) Use the screw removed at Step 1 to fix the stacking holder in the square hole.
(3) Put the rubber cap removed at Step 1 back into the square hole.
 • Snapthetabsonbothoftherubbercapintotheslitsonbothsidesinthesquarehole.
(1) (2) (3)