Operation Manual

14
2. Projecting an Image (Basic Operation)
Using the Supplied Power Cord Stopper
TopreventthepowercordfromaccidentlyremovingfromtheACINoftheprojector,attachthesuppliedpowercord
stoppertoclampthepowercord.
NOTE:
• Donotclampthepowercordwithothercables.Doingsocangeneratenoise,whichcanaffectadverselythesignalcable.
CAUTION
• Donotbundlethepowercord.Doingthiscouldcauseheatorare.
• Donotclamptwopowercordsthatwouldbeusedwhenstackingtwoprojectors.Doingthiscouldcausea
re.
NOTE:Becarefulnottoinsertthebandinversely.Oncethebandisattached,itcannotberemovedfromtheslot.
Attaching the power cord stopper
1. InserttheendofbandofthepowercordstopperintotheslotnexttotheACINontheterminalpanel.
2. Usethepowercordstoppertoclampthepowercord.
Push the clamper to lock it.
Clamper
3. Slidetheclampertothehiltofthepowercord.