Installation and Setup Guide

ManualsBrandsNEC ManualsMultimedia ProjectorsNEC NP-PX800X

Model: SCP200

3215 W. North Ave. • Melrose Park, IL 60160 • (800) 865-2112 or (708) 865-8870 • Fax: (708) 865-2941 • www.peerlessmounts.com

Maximum Load UL Capacity: 60 lb (27.2 kg)

Installation and Assembly:

Lightweight Adjustable Suspended Ceiling Plate for Projector

Mounts

ISSUED: 12-16-04 SHEET #: 120-9015-3 11-05-10

NEC DISPLAY SOLUTIONS OF AMERICA, INC.

USC

Summary of content (6 pages)

PAGE 1
NEC DISPLAY SOLUTIONS OF AMERICA, INC. Installation and Assembly: Lightweight Adjustable Suspended Ceiling Plate for Projector Mounts Model: SCP200 C UL © US Maximum Load UL Capacity: 60 lb (27.2 kg) ISSUED: 12-16-04 SHEET #: 120-9015-3 11-05-10 3215 W. North Ave. • Melrose Park, IL 60160 • (800) 865-2112 or (708) 865-8870 • Fax: (708) 865-2941 • www.peerlessmounts.
PAGE 2
NOTE: Read entire instruction sheet before you start installation and assembly. WARNING • Do not begin to install your product until you have read and understood the instructions and warnings contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, call Peerless customer care at 1-800-729-0307.
PAGE 3
Before you start check the parts list to insure all of the parts shown are included. NOTE: You may not need all hardware provided. Parts List A B C D E F G H I J Description ceiling plate M5 x 10 mm penta pin screw M5 penta pin driver M5 x 10 mm self tapping screw steel cable flush mount tube wood screw concrete anchor cable lock escutcheon plate Qty.
PAGE 4
IMPORTANT: Ceiling Tray (A) is designed to fit above a 24" (610 mm) x 24" (610 mm) section of a conventional suspended ceiling system. It may also be mounted above 24" x 48" conventional suspended ceiling. Ceiling runners (see figure 1.1) should have a "T" cross section and a minimum height of 1.5" (38 mm). 1 Place ceiling tray (A) in grid above 24" x 24" or 24" x 48" false ceiling tile so that lip of ceiling tray (A) rests on ceiling runners as shown in figure 1.1.
PAGE 5
4 Drill holes for four ceiling anchors (detail 2). Position the holes so that when the steel cables (E) are attached and taut they will angle out at 15°. DETAIL 2 Wood Joists or Beams Drill 5/32" (4 mm) dia. holes to a minimum depth of 1.5" (38 mm). Secure steel cables (E) using wood screw (G) Solid Concrete Drill 5/16" (8 mm) dia. holes to a minimum depth of 2.25" (57 mm). Hammer in concrete anchors (H) and secure steel cables (E) with wood screw (G) E E G Truss Ceiling No anchor required.
PAGE 6
LIMITED FIVE-YEAR WARRANTY Peerless Industries, Inc. establishes a warranty period of five years for products manufactured or supplied by Peerless. This period commences from the date of sale of the product to the original consumer, but will in no case last for more than six years after the date of the product’s manufacture.