NP03Wi Interactive White Board Kit SOFTWARE MANUAL This manual describes installation and operation procedures of the driver / the calibration software for NP03Wi Interactive White Board Kit 1
Operating Environment Supported OSs are as follows: Windows 7, Windows 8/8.1 * For starting up the software, Microsoft .NET Framework 4 or later is required. Download the Microsoft .NET Framework from the website of Microsoft and install it onto the computer. About trademarks Microsoft, Windows, .NET Framework are either registered trademarks or trademarks of Microsoft Corporation in the U.S. or other countries.
4. Select I accept the terms in the License Agreement and click Next Displays the selection screen of the installation destination folder. 5. Click [Next>]. After that, follow the displayed instructions to complete installation. When the installation is complete, an IWB icon is added to the desktop.
How to uninstall the software 1. Click [Control Panel] in the start menu, and double-click [Add or Remove Programs]. 2. Right-click [NP03Wi IWB] and click [Uninstall] in the list. After that, follow the displayed instructions to complete uninstallation. 3. When uninstallation is completed properly, reboot the computer.
Startup the Software Preparation: First of all, perform setup according to the installation manual enclosed with NP03Wi. If the computer and the camera unit are not connected by a USB cable, the message at right would be displayed on and the software would not be started up. For starting up the software, Microsoft .NET Framework 4 or later is required. If Microsoft .NET Framework is not installed on the computer, visit the website of Microsoft for download and install it on the computer. 1.
Performing Calibration Before starting to use the stylus pen, make sure to perform calibration in order to make the computer to recognize exact position of the stylus pen. Automatic calibration Manual calibration Automatically calibrate the stylus pen position. Recommend this when easy calibration is preferred. Manually calibrate the stylus pen position. Recommend this for installing the projector permanently or when precise calibration is preferred.
2. Press the center of the red dot with the stylus pen. The red dot is indicated at 25 points in order on the screen. Press briefly on the red dot to calibrate (see top left) Press [ESC] to cancel calibration Press [b] to undo last point When all points indicated by the red dot are pressed by the stylus pen, calibration is completed and the calibration completion message is displayed on. 3. Touch icon in the task tray by the stylus pen. This message is popped up when calibration is completed properly.
Troubleshooting You can check the installation condition of the camera unit when the troubleshooting in the IWB setup menu is displayed on. Troubleshooting screen Switch to the calibration menu Change the stylus pen status. If clicking / pressing this by the mouse / the stylus pen when PAUSE CALIBRATION is indicated on this button, the stylus pen becomes unavailable. If clicking this by the mouse when RESUME CALIBRATION is indicated on this button, the stylus pen becomes ready to use.