Owner's Manual

3. Projecting an Image (Basic Operation)

Thissectiondescribeshowtoturnontheprojectorandtoprojectapictureontothescreen.

Turning on the Projector

1. Press the (POWER) button on the projector cabinet

or the POWER ON button on the remote control.

The POWER indicator will turn to green and the projector

will become ready to use.

NOTE: When the projector is turned on, it may take some time

before the lamp light becomes bright.

TIP:

• WhentheSTATUSindicatorlightsorange,itmeansthatthe

[CONTROLPANELLOCK]isturnedon.(→ page 56)

After you turn on your projector, ensure that the computer

or video source is turned on.

NOTE:Whennosignalisavailable,theNEClogo(default),blue,or

blackscreenwillbedisplayed.Afteralapseof45secondsfromwhen

theprojectordisplaysablue,blackorlogoscreen,[ECOMODE]will

alwaysswitchto[ON].Thisisdoneonlywhen[ECOMODE]isset

to[OFF].

Standby

Preparingtopoweron

PowerOn

Steady orange light Blinking green light Steady green light

(→page67)