Owner's Manual

19
3. Projecting an Image (Basic Operation)
Selecting a Source
Selecting the computer or video source
NOTE:Turnonthecomputerorvideosourceequipmentconnectedtotheprojector.
Selecting from Source List
PressandquicklyreleasetheSOURCEbuttonontheprojectorcabinettodisplay
theSourcelist.EachtimetheSOURCEbuttonispressed,theinputsourcewill
changeasfollows:“COMPUTER”,“VIDEO”,“HDMI”.Todisplaytheselected
source,presstheENTERbuttonorallow2secondstoelapse.
Detecting the Signal Automatically
PresstheSOURCEbuttononce.Theprojectorwillsearchfortheavailableinput
sourceanddisplayit.Theinputsourcewillchangeasfollows:
VE280X/VE280:
COMPUTER→VIDEO→COMPUTER→ ...
VE281X/VE281/VE282X/VE282:
COMPUTER→VIDEO→HDMI→COMPUTER→ ...
TIP: If no input signal is present, the input will be skipped.
Using the Remote Control
VE280X/VE280:PressanyoneoftheCOMPUTER1andVIDEObuttons.
VE281X/VE281/VE282X/VE282:Pressany one of the COMPUTER1, HDMI
andVIDEObuttons.
Selecting Default Source
Youcansetasourceasthedefaultsourcesothatitwillbedisplayedeachtime
theprojectoristurnedon.
1. Press the MENU button.
The menu will be displayed.
2. Press the button twice to select [SETUP] and press the button or
the ENTER button to select [GENERAL].
3. Press the button four times to select [OPTIONS(2)].
4. Press the button five times to select [DEFAULT SOURCE SELECT] and
press the or button.
5. Select a source as the default source.
6. Press the EXIT button a few times to close the menu.
7. Restart the projector.
The source you selected in step 5 will be projected.
TIP:WhentheprojectorisinStandbymode,applyingacomputersignalfromacomputer
connectedtotheCOMPUTERINinputwillpoweron theprojectorandsimultaneously
projectthecomputer’simage.
[AUTOPOWERON(COMP.)](→ page 60)
VE280X/VE280
VE281X/VE281/VE282X/VE282