Owner's Manual

42
4. Convenient Features
Troubleshooting on viewing 3D images
Ifimageswillnotbedisplayedin3Dor3Dimagesappearas2D,checkthefollowingtable.Alsorefertotheuser's
manualaccompaniedwithyour3DcontentorLCDshuttereyeglasses.
Possible causes Solutions
• Thecontentyouareplayingbackisnotcompatiblewith3D. • Playbackacontentcompatiblewith3D.
• The3Dmodewasturnedofffortheselectedsource.
• Usetheprojector'smenutoturnon3Dmodefortheselected
source. (→page61)
• YouarenotusingourrecommendedLCDshuttereyeglasses.
• UseourrecommendedLCDshuttereyeglasses.(→page39)
• IftheshutterofyourLCDshuttereyeglassescannotsynchronize
withthecurrentlyprojectedsource,thefollowingarepossible
causes:
- YourLCDshuttereyeglassesarenotswitchedon. • SwitchonyourLCDshuttereyeglasses.
- ThebatteryintheLCDshuttereyeglassesrandown. • Rechargethebatteryorreplaceit.
- Thecorrecteyeglassmethodisnotselected.
• Changetheeyeglassmethodfor3Dbyusingthemenu..(→
page61)
- Theviewingdistancebetweentheviewerandthescreenis
toofar.
• Moveclosertothescreenuntiltheviewergets3Dimages.
• Orusetheprojector'smenutoselect[NON-INVERT]for[L/R
INVERT].
- Therearebrightlightsourcesorotherprojectorsnearthe
viewer.
• Keeplightsourcesorotherprojectorsawayfromtheviewer.
• Donotlooktowardabrightlightsource.
• Orusetheprojector'smenutoselect[NON-INVERT]for[L/R
INVERT].
• Ifyourcomputerisnotsetfor3Dviewing,thefollowingare
possiblecauses:
- Your computer does not meet the requirements for 3D
viewing.
• Checktoseeifyourcomputermeetstherequirementsprovided
inyouruser'smanualincludedwithyour3Dcontent.
- Yourcomputerisnotsetfor3Doutput. • Setyourcomputerfor3Doutput.
- Theresolutionofoutputsignalisoutofrange. • Selecttheresolutionofoutputsignalsupporting3D.
- Therefreshrateofoutputsignalisoutofrange. • Changetherefreshrateto120Hz.