Owner's Manual

Important Information

- Iftheprojectordoesnotoperatenormallywhenyoufollowtheinstructionsdescribedinthisuser'smanual.

- Iftheprojectorhasbeendroppedorthecabinethasbeendamaged.

- Iftheprojectorexhibitsadistinctchangeinperformance,indicatinganeedforservice.

• Disconnectthepowercordandanyothercablesbeforecarryingtheprojector.

• Turnofftheprojectorandunplugthepowercordbeforecleaningthecabinet.

• Turnofftheprojectorandunplugthepowercordiftheprojectorisnottobeusedforanextendedperiodoftime.

CAUTION

• Donotusethetilt-footforpurposesotherthanoriginallyintended.Misusessuchasusingthetiltfoottocarryor

hang(fromthewallorceiling)theprojectorcancausedamagetotheprojector.

• Donotsendtheprojectorinthesoftcasebyparceldeliveryserviceorcargoshipment.Theprojectorinsidethe

softcasecouldbedamaged.

• Select[HIGH]inFanmodeifyoucontinuetousetheprojectorforconsecutivedays.(Fromthemenu,select

[SETUP]→[OPTIONS(1)]→ [FANMODE]→[HIGH].)

• DonotturnofftheACpowerfor60secondsafterthelampisturnedonandwhilethePOWERindicatorisblinking

green.

 Doingsocouldcauseprematurelampfailure.

• PartsoftheprojectormaybecometemporarilyheatediftheprojectoristurnedoffwiththePOWERbuttonorif

theACpowersupplyisdisconnectedduringnormalprojectoroperation.

 Usecautionwhenpickinguptheprojector.

Remote Control Precautions

• Handletheremotecontrolcarefully.

• Iftheremotecontrolgetswet,wipeitdryimmediately.

• Avoidexcessiveheatandhumidity.

• Donotheat,takeapart,orthrowbatteriesintore.

• Ifyouwillnotbeusingtheremotecontrolforalongtime,removethebatteries.

• Ensurethatyouhavethebatteries'polarity(+/–)alignedcorrectly.

• Donotusenewandoldbatteriestogether,orusedifferenttypesofbatteriestogether.

• Disposeofusedbatteriesaccordingtoyourlocalregulations.

Lamp Replacement

• To replace the lamp, please contact your service dealer. The lamp is not user replaceable parts, and there

is not an optional lamp.

• Be sure to replace the lamp when the message [THE LAMP HAS REACHED THE END OF ITS USABLE LIFE,

PLEASE CONTACT YOUR SERVICE DEALER.] appears. If you continue to use the lamp after the lamp

has reached the end of its usable life, the lamp bulb may shatter, and pieces of glass may be scattered in

the lamp case. Do not touch them as the pieces of glass may cause injury. If this happens, contact your

dealer for lamp replacement.

A Lamp Characteristic

Theprojectorhasahigh-pressuremercurylampasalightsource.

Alamphasacharacteristicthatitsbrightnessgraduallydecreaseswithage.Alsorepeatedlyturningthelampon

andoffwillincreasethepossibilityofitslowerbrightness.