Operation Manual

17
3. Projecting an Image (Basic Operation)
SOURCE
AUTO
ADJ.
ON/STAND BY
FOCUS
LAMP
STATUS
POWER
SOURCE
AUTO
ADJ.
ON/STAND BY
FOCUS
LAMP
STATUS
POWER
Note on Startup screen (Menu Language Select screen)
Whenyourstturnontheprojector,youwillgettheStartupmenu.Themenugivesyoutheopportunitytoselect
themenuinoneofthe21languages.
To select a menu language, follow these steps:
1. Use the ▲
,
▼
,
◀ or ▶ button to select one of the 21
languages from the menu.
2. Press the ENTER button to execute the selection.
Afterthis has been done,youcan proceed to themenu op-
eration.
Ifyouwant,youcanselectthemenulanguagelater.(→[LAN-
GUAGE]onpage65)
NOTE:
• Ifoneofthefollowingthingshappens,theprojectorwillnotturnon.
- Iftheinternaltemperatureoftheprojectoristoohigh,theprojectordetectsabnormalhightemperature.Inthiscondition
theprojectorwillnotturnontoprotecttheinternalsystem.Ifthishappens,waitfortheprojector’sinternalcomponentsto
cooldown.
- Whenthelampreachesitsendofusablelife,theprojectorwillnotturnon.Ifthishappens,replacethelamp.
- Ifthelampfailstolight,andiftheSTATUSindicatorashesonandoffinacycleofsixtimes,waitafullminuteandthen
turnonthepower.
• TheprojectorcannotbeturnedoffwiththeON/STANDBYbuttonorthePOWEROFFbuttonwhilethePOWERindicator is
ashinggreeninacycleof0.5secondonand0.5secondoff.
• DonotdisconnecttheACpowersupplytotheprojectorfor60secondsimmediatelyafterturningitonanddisplayinganim-
age.
• Immediatelyafterturningontheprojector,screenickermayoccur.Thisisnormal.Wait3to5minutesuntilthelamplight-
ingisstabilized.
• Ifyouturnontheprojectorimmediatelyafterthelampisturnedofforwhenthetemperatureishigh,thefansrunwithoutdis-
playinganimageforsometimeandthentheprojectorwilldisplaytheimage.
＋
＋