Operation Manual

43
5. Using the Viewer (NP64/NP54)
3. Press the ◀ to select [OK] and press the ENTER
button.
The conrmation message will be displayed at the
center of the screen.
4. Press the ENTER button.
The conrmation message will be changed.
5. Remove the USB memory from the projector.
NOTE: Ifyou remove theUSBmemoryfrom theprojector
without using [REMOVEUSB DEVICE]from themenu, the
projectormaynotoperatecorrectly.Ifthishappens,turnoff
the projector andunplugthepower cable.Wait 3minutes,
thenconnectthepowercable,andturnontheprojector.
Exiting the Viewer
1. Press the MENU button with the slide screen or
the thumbnail screen displayed.
The control bar or the pop-up menu will be dis-
played.
2. Press the MENU button again.
The on-screen menu will be displayed.
3. Select a source other than [VIEWER] and press
the ENTER button.
The Viewer will be exited.
TIP: Toexit the Viewerusing the remote control, select a
sourceotherthan[VIEWER].