Solutions Inc. PlasmaSync User's Manual PX-50XM4A

ManualsBrandsNEC ManualsMonitorPlasmaSync 50XM4

PlasmaSync Plasma Monitor

NEC Solutions (America), Inc.

Model Information

For the operation of your plasma monitor,

refer to “Operation Manual”.

Summary of content (8 pages)

PAGE 1
PlasmaSync Plasma Monitor Model Information For the operation of your plasma monitor, refer to “Operation Manual”. NEC Solutions (America), Inc.
PAGE 2
PAGE 3
Important Information Warning NOTE: When you connect a computer to this monitor, use an RGB cable including the ferrite core on both ends of the cable. And regarding DVI and power cable, attach the supplied ferrite cores. If you do not do this, this monitor will not conform to mandatory FCC standards. Attaching the ferrite cores: Set the ferrite cores on both ends of the DVI cable (not supplied), and both ends of the power cable (supplied). Close the lid tightly until the clamps click.
PAGE 4
Recommandations importantes Avertissement REMARQUE: Pour raccorder un ordinateur à ce moniteur, procéder à l’aide d’un câble RGB à âme de ferrite aux deux extrémités. Sur les câbles DVI et les câbles d’alimentation électrique, fixer les âmes de ferrite fournies aux extrémités. Si vous ne le faîtes, le moniteur ne sera pas en conformité avec les exigences des standards FCC. Fixation des noyaux en ferrite.
PAGE 5
Specifications Color Processing Signals Synchronization Range Input Signals Horizontal : 15.5 to 110 kHz (automatic : step scan) Vertical : 50.0 to 120 Hz (automatic : step scan) RGB, NTSC (3.58/4.
PAGE 6
PAGE 7
Table of Signals Supported Supported resolution • When the screen mode is NORMAL, each signal is converted to a 1024 dots⳯768 lines signal. (Except for *2, 3, 4) • When the screen mode is TRUE, the picture is displayed in the original resolution. • When the screen mode is FULL, each signal is converted to a 1365 dots⳯768 lines signal.
PAGE 8
*1 *2 *3 *4 *5 Only when using a graphic accelerator board that is capable of displaying 852⳯480. This signal is converted to a 1024 dots ⳯ 640 lines signal. The picture is displayed in the original resolution. The aspect ratio is 5:4. This signal is converted to a 960 dots⳯768 lines signal. Normally the RGB select mode suite for the input signals is set automatically. If the picture is not displayed properly, set the RGB mode prepared for the input signals listed in the table above.