PlasmaSync Plasma Monitor Model Information For the operation of your plasma monitor, refer to “Operation Manual”. NEC Solutions (America), Inc.
Important Information Warning NOTE: When you connect a computer to this monitor, use an RGB cable including the ferrite core on both ends of the cable. And regarding DVI and power cable, attach the supplied ferrite cores. If you do not do this, this monitor will not conform to mandatory FCC standards. Attaching the ferrite cores: Set the ferrite cores on both ends of the DVI cable (not supplied), and both ends of the power cable (supplied). Close the lid tightly until the clamps click.
Recommandations importantes Avertissement REMARQUE: Pour raccorder un ordinateur à ce moniteur, procéder à l’aide d’un câble RGB à âme de ferrite aux deux extrémités. Sur les câbles DVI et les câbles d’alimentation électrique, fixer les âmes de ferrite fournies aux extrémités. Si vous ne le faîtes, le moniteur ne sera pas en conformité avec les exigences des standards FCC. Fixation des noyaux en ferrite.
Specifications 42VP4PA/42VP4DP-A Color Reproduction Signals Synchronization Range Input Signals 2.32" (59) 36.3" (921) 3.5" Horizontal : 15.5 to 110 kHz (automatic : step scan) Vertical : 50.0 to 120 Hz (automatic : step scan) RGB, NTSC (3.58/4.
Table of Signals Supported 42Wide VGA Supported resolution • When the screen mode is NORMAL, each signal is converted to a 640 dots 480 lines signal (42Wide VGA). (Except for *2, *4) • When the screen mode is FULL, each signal is converted to a 853 dots 480 lines signal (42Wide VGA).
*1 *2 *3 *4 *5 Only when using a graphic accelerator board that is capable of displaying 852 480. Display only 400 lines (42Wide VGA) with the screen center of the vertical orientation located at the center. The picture is displayed in the original resolution. The picture will be compressed for other signals. Aspect ratio is 5:4. This signal is converted to the following signal (42Wide VGA: 600 dots 480 lines). Normally the RGB select mode suite for the input signals is set automatically.