PlasmaSync Plasma Monitor Model Information For the operation of your plasma monitor, refer to “Operation Manual”. NEC Solutions (America), Inc.
IMPORTANT SAFETY INSTRUCTIONS (42XM2A/S) Read before operating equipment 1. 2. 3. 4. 5. 6. 7. Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with a dry cloth. Do not block any of the ventilation openings. Install in accordance with the manufacturers instructions. 8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9.
PRÉCAUTIONS IMPORTANTES DE SÉCURITÉ (42XM2A/S) A lire avant de faire fonctionner l’appareil 1. 2. 3. 4. 5. 6. 7. Lire ces instructions. Garder ces instructions. Respecter tous les avertissements. Suivre toutes les instructions. Ne pas utiliser cet appareil près de l’eau. Nettoyer seulement avec un chiffon sec. Ne pas boucher les ouvertures d’aération. Installer selon les instructions du fabricant 8.
Important Information Warning NOTE: When you connect a computer to this monitor, use an RGB cable including the ferrite core on both ends of the cable. And regarding DVI and power cable, attach the supplied ferrite cores. If you do not do this, this monitor will not conform to mandatory FCC standards. Attaching the ferrite cores: Set the ferrite cores on both ends of the DVI cable (not supplied), and both ends of the power cable (supplied). Close the lid tightly until the clamps click.
Recommandations importantes Avertissement Attention Ne pas utiliser dans une salle d’ordinateurs telle que définie dans la Norme pour la protection des ordinateurs électroniques/appareils de traitement des données ANSI/ NFPA75. Le 42XM2A/S est destiné à être utilisé uniquement avec les unités optionnelles suivantes. Toute utilisation avec d’autres unités optionnelles peut entraîner l’instabilité du placement.
Specifications Color Reproduction Signals Synchronization Range Input Signals 1.38" (35) 40" (1018) 2.13" (54) 36.1" (918) Horizontal : 15.5 to 110 kHz (automatic : step scan) Vertical : 50.0 to 120.0 Hz (automatic : step scan) RGB, NTSC (3.58/4.43), PAL (B,G,M,N), PAL60, SECAM, HD*1 , DVD*1 , DTV*1 24" (610) Aspect Ratio Resolution Pixel Pitch 36.1"(H)⳯20.4"(V) inches 918(H)⳯518(V) mm diagonal 42" 16 : 9 1024(H)⳯768(V) pixels 0.036"(H)⳯0.027"(V) inches 0.897(H)⳯0.
Table of Signals Supported Supported resolution • When the screen mode is NORMAL, each signal is converted to a 768 dots⳯768 lines signal. (Except for *2, *4) • When the screen mode is FULL, each signal is converted to a 1024 dots⳯768 lines signal.
*1 *2 *3 *4 *5 Only when using a graphic accelerator board that is capable of displaying 852⳯480. Display only 640 lines with the screen center of the vertical orientation located at the center. The picture is displayed in the original resolution. The picture will be compressed for other signals. Aspect ratio is 5:4. This signal is converted to a 720 dots⳯768 lines signal. Normally the RGB select mode suite for the input signals is set automatically.