User manual

Operations Commands 92
Operations Commands
Introduction
Operations-level commands are used for making immediate and temporary changes to switch configuration.
Operations commands are used for bringing ports temporarily in and out of service. These commands are available
only from an administrator and operator login.
The following table describes basic Operations commands. The following sections provide more detailed
information and commands.
Table 110 Operations commands
Command Description
password
Allows the user to change the password. You need to enter the current password in
use for validation.
clear logging
Clears all Syslog messages.
Command Mode: Priv EXEC
ntp send
Allows the user to send requests to the NTP server.
Command Mode: Priv EXEC
Operations-level port options
Operations-level port options are used for temporarily disabling or enabling a port.
Table 111 Operations-Level Port commands
Command Description
[no] rmon Enables or disables Remote Monitoring for the port. RMON must be enabled
for any RMON configurations to function.
Command mode: Interface port
no interface
gigabitethernet <port
number> shutdown
Temporarily enables the port. The port will be returned to its configured
operation mode when the switch is reloaded.
Note: This command does not enable a port that has been disabled by an
ekeying mismatch error.
Command Mode: Priv EXEC
interface gigabitethernet
<port number> shutdown
Temporarily disables the port. The port will be returned to its configured
operation mode when the switch is reloaded.
Command Mode: Priv EXEC
show interface
gigabitethernet <port
number> operation
Displays the current settings for the port.
Command Mode: Priv EXEC