Operation Manual

4
1. Introduction
 Part Names of the Projector
Top and Screen Side of Projector
Controls
(→ page 7)
FilterCover/IntakeVent/Filter
(→ page 116, 123)
Spacer (Left/Right)
To fine-adjust the height of the rear
foot, remove the spacer and rotate
the rear foot to the desired height.
(→ page 21)
Projection Window
Focus Ring
(→ page 20)
Tilt Foot
(→ page 21)
Built-in Security Slot (
)*
Lamp Cover
(→ page 121)
Security chain opening
Attach an anti-theft device.
The security chain opening accepts
security wires or chains up to 0.18
inch/4.6 mm in diameter.
* ThissecurityslotsupportstheMicroSaver
®
SecuritySystem.
MonauralSpeaker(16W)
Terminal Panel (→ page 8)
ACInput
Connect the supplied power cord’s
three-pin plug here, and plug the
other end into an active wall outlet.
(→ page 15)
Remote Sensor
(→ page 10)
Screw Hole for Cable Cover (Left/
Right)
(→ page 5)
Terminal Panel Side of Projector
IntakeVent/Filter
(→ page 116, 123)
Exhaust Vent