Xen IPK IAD MEGACO TRUNK EXTENSION QUICK SETUP GUIDE NEC Business Solutions Ltd Document No.: 8684 Release: 1.
NEC Business Solutions Ltd June 2004 Doc. No. 8684 - Release 1.
Disclaimer NEC shall not be liable for any direct, indirect, consequential or incidental damages about the use of this equipment, manual or any related materials. The information in this technical manual is advisory in nature and is subject to change. NEC may make improvements and changes in the products described in this manual without notice. Changes will be periodically made to the information in the new editions. Efforts have been made to ensure that the contents of this manual are correct.
June 2004 NEC Business Solutions Ltd Doc. No. 8684 - Release 1.
Setting Up the Megaco Station Application SECTION 1 HARDWARE SETUP Doc. No. 8684 - Release 1.
June 2004 NEC Business Solutions Ltd 1.1 Boot Up Sequence The LED chart shows the status of the IAD(8)-U( ) ETU card during boot up. The LED conditions change as the IAD(8)-U( ) ETU passes through different boot states.
Xen IPK SECTION 2 XEN IPK PROGRAMMING Xen IPK Programming After the Dip Switches have been set and the IAD ETU has been installed in the Xen IPK KSU, you are ready to program the settings the for the IAD ETU. The IAD (8)-U( ) ETU (MEGACO Station) is recognised by the Xen IPK system as a ESI(8)-U( ) ETU. This ETU takes a longer time to initialize than the other Xen IPK ETUs and must be programmed using Memory Block 7-1 (Card Interface Slot Assignment). 2.
June 2004 SECTION 3 IAD (8)-U( ) ETU WEB PROGRAMMING NEC Business Solutions Ltd When installed for the first time, the IAD (8)-U( ) ETU, comes up with factory set default parameters as shown in Table D-2 Factory Network Settings. Table D-2 Factory Network Settings Host Name neciad IP Address 192.168.1.100 Subnet Mask 255.255.255.0 Default Gateway 192.168.1.
