Installation Instructions

5.Release button → red led blinks
Green led blinks when restarted in unprovisioned mode.
During step 2 - 5, there is a timeout value of 3 s (from the first blink). If the required action is
not performed within 3 s after the led indication started, the factory reset is aborted.
A led blink is a 3 times loop of 100 ms on, 500 ms off.
Below is an illustration of action sequence for performing factory reset.
Restart and Reset Satellites
The button for restarting and factory resetting is located inside a hole on one short side of
the Satellite. You will need a paperclip or other thin object to push it.
Press the button 2 times (within 3 seconds of each button press) to perform a restart.
A provisioned Satellite will show a green LED for 10 seconds.
In an unprovisioned state it will show a yellow LED for 10 seconds.
Press the button 3 times (withing 3 seconds of each button press) to perform a factory reset.
The LED will light Yellow for 10 seconds.
The Wristband
The Wristband is responsible for detecting movement and pressure changes. It gives
insights and enables Nectarine Health to detect falls by streaming data 24/7 in the home. It
contains a microphone that enables the Wearer to speak to Carers in case of an emergency
and a button for calling for assistance.
It’s designed to be discreet, is allergene friendly and waterproof which makes it possible to
wear it 24/7 for the most possible insights.
Document version: 1.0 7