Quick Start Manual

SmartTag Ear / Quick start manual
5288215 / Version 00.001 / November 2020 / EN
3
Dairy Farming
Technical specifications
SmartTag Ear
Item Specification
Electrical supply
Supply voltage Lithium coin cell 3,0 V (internal)
Antenna
Operating frequency (center) 433,3 - 434,5 MHz
Max. transmit power <1mW E.r.p.
Environmental
Operation temperature range -10 to 50 °C (14 to 122 °F)
Storage temperature range -20 to 70 °C (-4 to 158 °F)
Relative humidity (non-condensing) < 93% (non-condensing)
Protection against water and dirt IP67
Compliance
Certificates and declarations All relevant certificates and declarations are available at our Business Portal: http://
www.nedap.com/livestockmanagement-portal.
Compliance
Region
[1]
Certification
Europe
USA FCC ID: CGDFERPH
Canada IC: 1444A-FERPH
Australia
New-Zealand R-NZ
[1] All relevant certificates and declarations are available at our Business Portal: https://www.nedap.com/livestockmanagement-portal
FCC and ISED Compliance statement
This device complies with part 15 of the FCC Rules and with RSS-210 of Innovation, Science and Economic
Development Canada. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
Cet appareil se conforme aux normes CNR-210 exemptés de license d'Innovation, Sciences et Développement
économique Canada. L'opération est soumis aux deux conditions suivantes: (1) cet appareil ne doit causer aucune
interférence, et (2) cet appareil doit accepter n'importe quelle interférence, y inclus interférence qui peut causer une
operation non pas voulu de cet appareil.
Les changements ou modifications n'ayant pas été expressément approuvés par la partie responsable de la conformité
peuvent faire perdre à l'utilisateur l'autorisation de faire fonctionner le matériel.