Install Guide

SENSIT SYSTEM | MANUAL
Gateway Configuration
40/118
3G AND 4G CONFIGURATION
The 3G or 4G modem inside the SENSIT Gateway needs to be configured before it
can access the internet and connect to the SENSIT Interface Software at the server.
This is done by sending 2 SMS text messages to the SENSIT Gateway. Any GSM cell
phone can be used to send these configuration text messages.
7.2.1 PROFILE:
First the APN settings should be configured. These settings depend upon the mobile
network provider. The settings are sent in a SMS message using the following format:
PROFILE:APN=<apn>;APNLOGIN=<login>;APNPASSWORD=<pwd>;DNS=<dns>;
Where: <apn> APN (Access Point Name)
<login> User name
<pwd> Password
<dns> DNS (Domain Name Server)
Example:
PROFILE:APN=gprsinternet;APNLOGIN=gprs;APNPASSWORD=;DNS=;
Next the SENSIT server settings should be configured. These settings are provided to
you when the SENSIT Interface Software (SIS) is installed on the server. The settings
are sent in a SMS message using the following format:
PROFILE:HOSTNAME=<server>;PORT=<port>;SSL=<ssl>;
Where: <server> SENSIT server hostname or ip-address
<port> Port number
<ssl> true / false depending if SSL security is
used.
Example:
PROFILE:HOSTNAME=217.114.111.246;PORT=10000;SSL=false;
7.2.2 INFO:
To check the SIM card or the verify the mobile phone number a INFO SMS command
returns some detail information. The returned information is the IMEI number, the
IMSI number, mobile provider details, the signal quality and the software version.
Example:
INFO:
Note
Make sure the SMS does not
get longer than the default
message size of 160
characters.
Note
The SENSIT Gateway will
send a SMS back to the
phone number you send
the SMS with. All current
settings are transmitted
after sending a SMS
message.