Install Guide

SENSIT SYSTEM | MANUAL
Gateway Configuration
43/118
7.3.8 WSN LED INDICATIONS
The SENSIT Gateway is featured with two LEDs indicating the WSN (Wireless SENSIT
Network) operation. These LEDs can be found just above the tamper switch, see
Figure 28: SENSIT Gateway LED feedback. The table below describes the function of
the WSN LEDs.
SENSIT Gateway LED indication.
Green (D1)
LED indicating the presence of active Relay Nodes in
the wireless SENSIT network.
Red (D2)
LED indicating the activity of the SENSIT Gateway, the
Gateway is stated and maintaining the wireless
SENSIT network.
Table 1: LED indications
VERIFY COMMUNICATION
Via the SENSIT Interface Software (SIS) a more detailed description can be found in
chapter 17.1. After choosing: Detection ➔ Gateway choice at the left side of the
screen. The powered and to the internet connected SENSIT Gateways, should show
up automatically in the Gateways connected list.
Figure 29: Verify connected SENSIT Gateways at the SIS