Install Guide

SENSIT SYSTEM | MANUAL
Mounting The SENSIT BACKUP Battery
44/118
8 MOUNTING THE SENSIT BACKUP BATTERY
SAFETY PRECAUTIONS
The following safety precautions should be observed during normal use, service and
repair.
• The SENSIT backup battery may only be installed and serviced by qualified
service personnel.
• Disconnect the power supply of the SENSIT Gateway before removing or
installing the SENSIT backup battery.
• To be sure of safety, do not modify or add anything to the SENSIT backup
battery other than mentioned in this manual or indicated by NEDAP N.V
INSTALLATION CONDITIONS
The installation recommendation is based on the following environmental
conditions;
• Dry weather conditions.
REQUIRED INSTALLATION MATERIALS
The following would be required for mounting of the SENSIT backup battery. In case
of wall mounting.
• Special Equipment: Ladder, Bucket-truck or an aerial platform
• Power drill
• Set screw driver
• Wall plugs or anchors including screws
The needed materials for pole mounting are described at chapter 9.
MOUNTING
The SENSIT backup battery must be mounted in the close vicinity of Gateway. Often
it is installed back-to-back on a pole. Similar as the Gateway it can be installed
virtually anywhere due to its IP65 weatherproof housing.