Install Guide

SENSIT SYSTEM | MANUAL
mounting The SENSIT (IR) Flush Mount
57/118
Step 4:
Mounting
a) Push the SENSIT sensor halfway into
the cavity.
b) Tap gently on the top of the SENSIT
sensor to clear out any possible air
bubbles in the fixing material. Repeat
this process until the three ends of the
clip touch the road surface. This
installation process enables the fixing
material to rise evenly around the
SENSIT sensor.
c) If the cavity is not filled up
completely, extra fixing material
should be poured around the SENSIT
sensor.
d) Remove excessive fixing material and
clean the sensor when needed with a
wet sponge.
Step 5:
Cleaning-up
After mounting the SENSIT sensors in all
parking bays or a selection of parking bays.
Clean up the parking bays and remove all
(metal) tools and objects.
Step 6:
Activating
Segmentation
Calibration
Use the Configuration Tool: Activate,
perform the segmentation according the
installation plan and calibrate the SENSIT
sensor.
Step 7:
Glue curing
Allow the fixing material to cure. Please
refer to the curing time specifications of
the fixing material.
Step 8:
Mounting clip
ends removal
If required, the three ends of the SENSIT
Mounting Clip can be removed using side
cutters. Make sure to remove any sharp
ends.
Note
The fixing material should
be completely cured before
the three ends of the
SENSIT Mounting Clip can
be removed.