Install Guide

SENSIT SYSTEM | MANUAL
Advance Configuration
96/118
below a SENSIT Gateway with ID-number 8AB4 and a Relay Node with ID-number
8A9B is created and place at the right location in the map.
Figure 91: Inkscape, Create Node
When the drawing is finished the next step is to scale the drawing correctly so all
bays, Relay Nodes and SENSIT Gateways are nicely places in the map. First select al
objects, this can be done easily with Ctrl + A. Select: File -> Document Properties…
and then in Custom size, Resize page to content… add some top, bottom left and
right margin to the page and select the button Resize page to drawing or selection.
See also Figure 92 below.
Figure 92: Inkscape, Resize page
Further make sure you remove the viewBox item via the XML editor. The XML-editor
can be found via the menu Edit -> XML Editor… the viewBox item can be deleted
with the marked button, see screenshot below.
Note
Make sure the units is in
pixels (px) otherwise the
scaling in the monitor map
might not work properly.