Installation Instructions
1 2 3 4 5 6 7 8
Status LEDs
Antenna connector side
Connector side
connectors from smart deactivator
Status LEDs
Green = Power
Red = Label detected – 1 flash (Standard mode)
Label deactivated – 3 flashes (Standard mode)
Yellow = Output LED
Orange = Status LED
Depending on dipswitch settings, LED behaviour can be different. (See settings below)
4
5
2
1
3
program switch settings
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
9
10
7
6
8
11
12
Standard mode
Line Termination RS485
Detect only mode
Output after 10 seconds of detection
Forced deactivation, for 90 seconds after input signal
90 seconds
Input used as switch for buzzer volume
Counting output inverted - Standard mode
Detect only - Output inverted
Deactivation only if input is high
High = Low sensitivity
Low = Standard sensitivity
Remote operation address 1
Remote operation address 2
Version: > V7.5
Led Yellow Low after deactivation
Led Orange High at input signal
Led yellow Low after detection
Led orange Flash
Led yellow High after 10 seconds detection
Led orange Not used
Led yellow High after 10 seconds detection
Led orange High during deactivation
Led yellow Low after deactivation
Led orange High at input signal
Led yellow High pulse after deactivation
Led orange Not used
Led yellow High pulse after detection
Led orange Flash
Led yellow High pulse after detection
Led orange High during deactivation
DLL mode - Transaction Controlling
4 = high address 2
4 = low address 1 (standard)
*
*
*
*
In detect only mode, due to the RF detection eld, we cannot guarantee labels will never deactivate.
*
13
14
15
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
Output after 1 deactivation burst and still detection.
90 seconds
Led yellow High after detection
Led orange High during deactivation
Output after 2 deactivation bursts and still detection.
90 seconds
Led yellow High after detection
Led orange High during deactivation
Output after 3 deactivation bursts and still detection.
90 seconds
Led yellow High after detection
Led orange High during deactivation
Forced deactivation, for 90 seconds after input signal
Forced deactivation, for 90 seconds after input signal
Forced deactivation, for 90 seconds after input signal
Beeper default o.
Beeper default o.
Beeper default o.
Input
Deactivation
Input
Deactivation
Input
Deactivation