Instruction Manual

VP1004-B / Safety Instructions 5287782 /

Version 01.000 / December 2019 / EN

Livestock Management

2 Compliance

FCC and ISED Compliance statement

This device complies with part 15 of the FCC Rules and to RSS-210 of Innovation, Science and Economic Development

Canada. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2)

this device must accept any interference received, including interference that may cause undesired operation.

Changes or modiﬁcations not expressly approved by the party responsible for compliance could void the user's authority to

operate the equipment.

Cet appareil se conforme aux normes RSS 210 exemptés de license d'Innovation, Sciences et Développement

économique Canada. L'opération est soumis aux deux conditions suivantes: (1) cet appareil ne doit causer aucune

interférence, et (2) cet appareil doit accepter n'importe quelle interférence, y inclus interférence qui peut causer une

operation non pas voulu de cet appareil.

Les changements ou modiﬁcations n'ayant pas été expressément approuvés par la partie responsable de la conformité peuvent

faire perdre à l'utilisateur l'autorisation de faire fonctionner le matériel.

FCC and ISED Radiation Exposure Statement

This equipment complies with FCC and Canadian radiation exposure limits set forth for an uncontrolled environment.

This equipment should be installed and operated with a minimum distance of 3 cm between the radiator and your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Cet équipement est conforme a RSS-102 limites énoncées pour un environnement non contrôlé. Cet équipement doit

être installé et utilisé avec une distance minimale de 3 cm entre le radiateur et votre corps.

FCC and ISED Information to the user

Note: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15

of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequent energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does not

cause harmful interference to radio or television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver.

This Class B digital apparatus complies with the Canadian standard ICES-003. Cet appareil numérique de Classe B est

conforme à la norme Canadienne ICES-003.

Any changes or modiﬁcations not expressly approved by the party responsible for compliance could void the user's

authority to operate the equipment. To ensure compliance with FCC regulations, use only the shielded interface cables

provided with the product, or additional speciﬁed components or accessories that can be used with the installation of the

product.