User Manual

BOOSTER 2G | USER GUIDE
Smartcard Configuration
12/27
Calypso
Enable or disable the reading of Calypso cards.
Data to read:
For Calypso cards the 4-byte PUPI or information from always accessible files can be
read. The Booster does not support the Calypso SAM to fully support the Calypso
encrypted file system. Select one of the following choices:
• PUPI (pseudo unique PICC identifier)
• Calypso file data
Byte order
The byte order can be set to normal or reversed.
Short File Identifier
Calypso SFI (Short File Identifier) in range from 1 .. 30. Some files have no SFI. Only
files with an SFI are supported.
Record Number
A file may contain more than one record. Numbered from 1 to the maximum number
of records.
Data Length
Number of bytes to transmit. The maximum number of bytes is dependent upon the
operating-mode and frame-length settings.
Data Offset
Number of bytes to skip.
Reading MIFARE ultralight data
The Mifare UltraLight transponders’ 512 bit EEPROM memory is organized in 16
pages with 4 bytes each.
Page Number
Page number to start reading from (in range from 0 .. 15).
Always 4 pages are read. The reading will wrap around to page number 0 if
additional data after page 15 should be read.
Data Length
Number of bytes to transmit. The maximum number of bytes is dependent upon the
operating-mode and frame-length settings.
Data Offset
Number of bytes to skip.