User Manual

BOOSTER 2G | USER GUIDE
Smartcard Configuration
18/27
4.3 ROGRAM THE CONFIGURATION CARD
4.3.1 USING A SUPPORTED PROGRAMMER
The software supports a few different programming devices. The NXP Pegoda, the
HID OMNIKEY 5x21 and PC/SC contactless readers from the Springcard CSB6 Family
(e.g. Prox 'n' Roll PC/SC).
NXP Pegoda Programmer
Connect the NXP Pegoda Mifare programmer to a USB port on
your computer. USB drivers must be installed as described in
the NXP documentation.
In the ‘Programmer’ menu select the 'NXP Pegoda' and click
‘Connect’ to connect to the programmer.
HID OMNIKEY 5x21-CL Programmer
Connect the HID OMNIKEY 5x21-CL USB programmer to a USB
port on your computer. USB drivers must be installed as
described in HID documentation.
In the ‘Programmer’ menu select 'HID OMNIKEY' and click
‘Connect’.
SPRINGCARD CSB6
The SpringCard CSB6 and Prox 'n' Roll PC/SC share the same
architecture. Install the PC/SC drivers as described in the
SpringCard documentation. Connect the CSB6 to a USB port on
your computer.
In the ‘Programmer’ menu select 'SpringCard CSB6' and click
‘Connect’.
Programming
Once the connection has been established and all configuration settings are
entered, place an empty Mifare Classic 1K or 4K card on the programmer.
To program the configuration into the Mifare card click ‘Write configuration into
card’ in the ‘Programmer’ menu. The message ‘Configuration written into card’
should appear to indicate that the programming action was successful.
The software will warn you with the message ‘Overwrite configuration card’ if there
is already a configuration on the Mifare card. Click ‘Yes’ to proceed and overwrite
the configuration on the card or click ‘No’ to abort.
Read back
It is also possible to read back what configuration is programmed into a
configuration card. Click ‘Read configuration from card’ in the ‘Programmer’ menu.
Note
The HID OMNIKEY
programmer sometimes
requires to remove and
replace the config card
before re
-accessing the
card is possible.