User Manual

BOOSTER 2G | USER GUIDE
Smartcard Configuration
19/27
4.3.2 USING ANOTHER PROGRAMMER
If there is no supported programmer available you can use any other Mifare
programmer to write the configuration into a Mifare classic card.
The configuration data should be written into sector 1 and 2 of a Mifare Classic 1K or
4K card. The contents of these sectors is not explained, but can be shown by the
configuration software by clicking ‘Show configuration details’ in the ‘Expert’ menu.
Configuration Data
Sector 0 is reserved for MAD (Mifare Application Directory). If the MAD is
programmed, the Nedap configuration sectors should have application id 517F.
Copy to clipboard
Copy the configuration data to clipboard by clicking ‘Copy to clipboard’ in the ‘Edit’
menu.
Customizing view
In the ‘View’ menu the viewing can be customized in such way that it best matches
your programming software.
Click ‘Change Hex Prefix…’ to specify a specific prefix that is shown before every
configuration data byte. Below is shown the configuration data with prefix ‘0x’.
0x77 0x77 0x77 0x2E 0x6E 0x65 0x64 0x61 0x70 0x61 0x76 0x69 0x2E 0x63 0x6F 0x6D
0x4E 0x01 0x01 0x07 0x07 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x4E
0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00
0xA0 0xA1 0xA2 0xA3 0xA4 0xA5 0x78 0x77 0x88 0x00 0xB0 0xB1 0xB2 0xB3 0xB4 0xB5
Besides the hex prefix also the byte order can be changed from within the ‘View’
menu.