User's Manual

BOOSTERS
© Nedap IDEAS, P.O. Box 103, NL-7140 AC GROENLO Page 7 of 16
3.2.2.3 HIGH FREQUENCY
Enable HID iCLASS CSN
Enable or disable the reading of HID iCLASS transponders. Only the card serial number can be
read from these transponders.
Enable ISO14443-A / MIFARE
Enable or disable the reading of ISO14443-A / Mifare transponders.
Data to read from ISO14443-A / MIFARE
For ISO14443-A cards only the card serial number can be read. The cascaded card serial number
(e.g. used in Mifare UltraLight cards) is also supported. For MIFARE cards also other information
from the card can be read. Select one of the following choices:
; ISO14443-A card serial number
 MIFARE UltraLight data (see chapter 3.2.2.4 for more details)
 MIFARE Classic data from sector (see chapter 3.2.2.5 for more details)
Enable ISO15693 / LEGIC CSN
Enable or disable the reading of ISO15693 / LEGIC Advant transponders. Only card serial number
can be read from these transponders.
3.2.2.4 READING MIFARE ULTRALIGHT DATA
The Mifare UltraLight transponders’ 512 bit EEPROM memory is organized in 16 pages with 4 bytes
each.
Page Number
Page number to start reading from (in range from 0 .. 15).
Data Length
Number of bytes to read. The reading will wrap around to page number 0 if additional bytes after
page 15 should be read. The maximum number of bytes to read is 16.
Data Offset
Number of bytes to skip reading (in range from 0 .. 8).
Example:
Data to read: MIFARE UltraLight data
Page Number: 4
Data Length: 4
Data Offset: 2
The settings above will read the data below shown in blue.
Byte 0 Byte 1 Byte 2 Byte 3
Page 3 not read not read not read not read
Page 4 skipped skipped DATA DATA
Page 5 DATA DATA ignored ignored
Page 6 not read not read not read not read