User's Manual

BOOSTERS 2G
© Nedap IDEAS, P.O. Box 103, NL-7140 AC GROENLO Page 10 of 21
4.2.2.3 ACTIVE MODE
Two activation modes are possible: Switched or Always-on.
The setting can only be changed when the Booster originally was in switched mode !!!
Switched mode is selected when the operating mode is Booster (only Driver-ID).
Switched mode (active for approx. 5 seconds)
In switched mode the booster is active for approx. 5 seconds after the booster's button is pushed and
then autmatically returns into sleep mode.
Always-on (continuously active)
In always-on mode the booster remains active. When the booster's button is pushed the booster will read
the inserted card. If a card is identified, the booster will check every few minutes if the inserted card is still
present.
4.2.2.4 RFID CONFIGURATION
ISO14443-A / MIFARE
Enable or disable the reading of ISO14443-A / MIFARE cards.
Data to read:
For ISO14443-A cards the card serial number can be read. The cascaded card serial number (e.g. used in
Mifare UltraLight cards) is also supported. For MIFARE cards also other encrypted information from the
card can be read. Select one of the following choices:
 ISO14443-A card serial number
 MIFARE UltraLight data (see chapter 4.2.2.5 for more details)
 MIFARE Classic sector data (see chapter 4.2.2.6 for more details)
 MIFARE DESFIRE file data (see chapter 4.2.2.7 for more details)
The byte order can be set to normal or reversed.
NEDAP PM
 
Enable or disable the reading of NEDAP PM cards. NEDAP PM cards are always transmitted to the TRANSIT
using standard-length.
EM4102 (and compatible)

Enable or disable the reading of EM4102 and compatible cards. EM4102 cards are always transmitted to
the TRANSIT using standard-length.

HID PROX
Enable or disable the reading of HID PROX cards. HID PROX cards are always transmitted to the TRANSIT
using extended-length.

HID iCLASS CSN
Enable or disable the reading of HID iCLASS cards. Only the card serial number can be read from these
cards.
ISO15693 / LEGIC Advant CSN
Enable or disable the reading of ISO15693 / LEGIC Advant cards. Only card serial number can be read from
these cards.

Not supported on the Smartcard-Booster.

Cannot be disabled on MTR.