User's Manual
Table Of Contents
- 1 INTRODUCTION
- 2 INSTALLATION
- 3 IDENTIFYING THE BOOSTER WITH A TRANSIT
- 4 SMARTCARD CONFIGURATION
- 5 MTR CONFIGURATION
- 6 BUZZER INDICATIONS
- 7 BATTERY REPLACEMENT
BOOSTERS 2G
© Nedap IDEAS, P.O. Box 103, NL-7140 AC GROENLO Page 11 of 21
Calypso
Enable or disable the reading of Calypso cards.
Data to read:
For Calypso cards the 4-byte PUPI or information from always accessible files can be read. The Booster
does not support the Calypso SAM to fully support the Calypso encrypted file system. Select one of the
following choices:
PUPI (pseudo unique PICC identifier)
Calypso file data
Byte order:
The byte order can be set to normal or reversed.
Short File Identifier:
Calypso SFI (Short File Identifier) in range from 1 .. 30. Some files have no SFI. Only files with an SFI are
supported.
Record Number:
A file may contain more than one record. Numbered from 1 to the maximum number of records.
Data Length:
Number of bytes to transmit. The maximum number of bytes is dependant upon the operating-mode and
frame-length settings.
Data Offset:
Number of bytes to skip.