User's Manual
Table Of Contents
- 1 INTRODUCTION
- 2 INSTALLATION
- 3 IDENTIFYING THE BOOSTER WITH A TRANSIT
- 4 SMARTCARD CONFIGURATION
- 5 MTR CONFIGURATION
- 6 BUZZER INDICATIONS
- 7 BATTERY REPLACEMENT
BOOSTERS 2G
© Nedap IDEAS, P.O. Box 103, NL-7140 AC GROENLO Page 14 of 21
4.2.2.7 READING MIFARE DESFIRE FILE DATA
The MIFARE DESFIRE cards are fully supported. Also other newer DESFIRE EV1 cards can be used. Including the
DES, 3DES, 3 Key 3DES and AES encryptions.
The DESFIRE card's memory is organized using a flexible file system. This file system allows several different
applications on a single card. Every application is identified by it's 3 byte application identifier (AID). Each
application may contain up to 32 files.
Upon configuring the smartcard-booster for reading MIFARE DESFIRE cards, the following parameters must be
specified.
Application ID
Three byte application identifier (AID).
File number
File number in the range from 0 .. 31.
Communication mode
Plain.
Plain secured by MACing.
Fully enciphered.
Data Length
Number of bytes to transmit. The maximum number of bytes is dependant upon the operating-mode and
frame-length settings.
Data Offset
Number of bytes to skip.
Encryption
None (skip authentication)
Native DES/3DES
ISO DES/3DES
3 Key 3DES
AES
Key number
Key number in range from 0 to 13.
Key
Security authentication key. Depending upon the selected encryption method and key number. The
encryption key is 16 or 24 bytes.