User's Manual
Table Of Contents
- 1 INTRODUCTION
- 2 INSTALLATION
- 3 IDENTIFYING THE BOOSTER WITH A TRANSIT
- 4 SMARTCARD CONFIGURATION
- 5 MTR CONFIGURATION
- 6 BUZZER INDICATIONS
- 7 BATTERY REPLACEMENT
BOOSTERS 2G
© Nedap IDEAS, P.O. Box 103, NL-7140 AC GROENLO Page 16 of 21
4.3 PROGRAM THE CONFIGURATION CARD
4.3.1 USING A SUPPORTED PROGRAMMER
The software supports a few different programming devices. The NXP Pegoda, the HID OMNIKEY 5x21 and PC/SC
contactless readers from the Springcard CSB6 Family (e.g. Prox 'n' Roll PC/SC).
4.3.1.1 NXP PEGODA PROGRAMMER
Connect the NXP Pegoda Mifare programmer to a USB port on your computer. USB drivers
must be installed as described in the NXP documentation.
In the ‘Programmer’ menu select the 'NXP Pegoda' and click ‘Connect’ to connect to the
programmer.
4.3.1.2 HID OMNIKEY 5x21-CL PROGRAMMER
Connect the HID OMNIKEY 5x21-CL USB programmer to a USB port on your computer. USB
drivers must be installed as described in HID documentation.
In the ‘Programmer’ menu select 'HID OMNIKEY' and click ‘Connect’.
4.3.1.3 SPRINGCARD CSB6
The SpringCard CSB6 and Prox 'n' Roll PC/SC share the same architecture. Install the PC/SC
drivers as described in the SpringCard documentation. Connect the CSB6 to a USB port on
your computer.
In the ‘Programmer’ menu select 'SpringCard CSB6' and click ‘Connect’.
4.3.1.4 PROGRAMMING
Once the connection has been established and all configuration settings are entered, place an empty Mifare
Classic 1K or 4K card on the programmer.
To program the configuration into the Mifare card click ‘Write configuration into card’ in the ‘Programmer’ menu.
The message ‘Configuration written into card’ should appear to indicate that the programming action was
successful.
The software will warn you with the message ‘Overwrite configuration card’ if there is already a configuration on
the Mifare card. Click ‘Yes’ to proceed and overwrite the configuration on the card or click ‘No’ to abort.
4.3.1.5 READ BACK
It is also possible to read back what configuration is programmed into a configuration card. Click ‘Read
configuration from card’ in the ‘Programmer’ menu.
The HID OMNIKEY programmer sometimes requires to remove and replace the config card before re-
accessing the card is possible.