User's Manual
Table Of Contents
- 1 INTRODUCTION
- 2 INSTALLATION
- 3 IDENTIFYING THE BOOSTER WITH A TRANSIT
- 4 SMARTCARD CONFIGURATION
- 5 MTR CONFIGURATION
- 6 BUZZER INDICATIONS
- 7 BATTERY REPLACEMENT
BOOSTERS 2G
© Nedap IDEAS, P.O. Box 103, NL-7140 AC GROENLO Page 18 of 21
4.4 TESTING THE CONFIGURATION
The MIFARE settings can be tested before loading it into the Smartcard-Booster using a supported mifare reader.
From the ‘Programmer' menu choose ‘Test configuration’.
Place the Mifare card (not the config card) on the reader and click the ‘Read’ button.
The reader reads the Mifare card according to the current configuration settings.
The software displays the driver-id number as it will be identified by the TRANSIT.
Configuration Test
If the card is not read or if the wrong data is shown under DRIVER-ID then check if the configuration settings are
correct. Remember that only MIFARE cards can be tested this way.
4.5 CONFIGURATION FILES
Your configuration can be saved into a so-called Smartcard Booster Config File (*.sbcf). These files contain all the
configuration settings as you have defined them. Saved Config Files can be easily opened from within the File
menu.