User Manual

|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
10
Figure 6 - Top view, test and reset button
MOUNTING THE ECO READER
The Eco Reader can be mounted to a vertical surface by using the supplied DIN rail. Use the
appropriate screws and tools for the surface you are mounting on. The Eco Reader weighs
approximately 2.6kg, so make sure the surface can carry this weight. The Eco Reader can be ‘clicked’
on the DIN rail. Use the provided ‘power adapter mounting kit’ to attach the power supply to the
DIN rail to.
Although the Eco Reader does not produce much heat, and is passively cooled, it should not be
installed in a space where the temperature can rise above 50˚C.
CONNECTING THE ANTENNAS
The antenna connected to the Eco Reader should be a 50Ω@13.56Mhz resonant antenna. All Nedap
Librix gates fulfill this requirement. Only antennas produced or approved by Nedap Librix may be
connected to the Eco Reader.
When your Eco Reader is of version REV.A (which can be seen on top of the PCB), and/or it
has a warning sticker next to the BNC connectors, do not connect an unterminated coaxial
cable to one of its RF outputs! This may permanently damage the Eco Reader. To be sure,
turn off power before you do any work or maintenance on the Eco Reader.
TEST
RESET