User Manual

||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||| |
19
CONNECTING TO ETHERNET {OPTIONAL}
The Eco Reader can be connected to any 10/100Mbit network with shielded UTP cable. Use the LAN
connector on the PCB for this. The Eco Reader is default set to use DHCP to obtain an IP-address, but
can also be configured to a static IP-address. The program rftest.lite can be used to search for all Eco
Readers in the network, and in this way its IP-address can be retrieved.
Figure 15 Ethernet Connector
CONNECTING THE RELAIS {OPTIONAL}
The Eco Reader is equipped with 2x relais, with a common (C), normally open (NO) and normally
closed (NC) contact separately supplied on connector K8 for both of them. When an alarm sounds
the relais change their state. The amount of time before the relais change back to their ‘normal’
state can be configured in the settings.
The relais is of type ‘Omron G6S’ which can switch a purely resistive load with 2A at 30VDC. Please
refer to the datasheet of the relais on the manufacturer’s website for other specifications.