User Manual

ManualsBrandsNederlandsche Apparatenfabriek NEDAP ManualsElectronicsInductive RFID card Reader operating on 13.56 MHz

|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||

SOFTWARE CONFIGURATION

INTRODUCTION

This chapter describes how the Eco Reader can be configured. Most configuration needs to be done

when the Eco Reader is used in combination with Security Antennas. When the Eco Reader is used in

combination with Intelligent shelves, it is controlled from a PC. Rftest.lite 3.0.0 or higher may be

required when communication is done over USB.

RFTEST.LITE OR WEBPAGE?

The Eco Reader can be configured with the windows program rftest.lite or over its internal webpage.

When rftest.lite is used the Eco Reader can be configured over its usb connection or over its network

connection. When the webpage is used the Eco Reader must have a network connection and a

properly configured IP-address. When the IP-address is entered in a web browser, the internal

configuration page of the Eco Reader is shown, after the ‘Settings’ tab in the top-right corner is

clicked. It is advised to use the latest version of Firefox (14.0 or higher) , Chrome (20.0 or higher) or

Internet Explorer (9 or higher) to make sure that the page is properly displayed.

Figure 16 - Eco Reader internal webpage

USING THE WEBPAGE

The internal webpage of the Eco Reader has 2x tabs, whose buttons are located in the top-right

corner of the browser window:

 home

 settings

Home page

On the home page the customer counter values combined for all connected gates are shown. There

are two icons which show incoming and outgoing customers. E.g. in Figure 16 there are 103

incoming, and 100 outgoing customers. Please refer to chapter “Connecting Customer Counting” for

instructions on how to properly connect the customer counter sensors to the Eco Reader. These

values are updated regularly, without the need to refresh the webpage.