User Manual

|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
24
ADMINISTRATOR ACCESS
Some settings (like RFID output power) are only accessible when you are logged in into the Eco
Reader as administrator. In order to do this go to the top-right corner of the configuration webpage,
and enter in the ‘User’ and ‘Pass’ textboxes the following.
User: admin
Pass: admin
ENABLING POWER
To enable the output power of the Eco Reader, you need to be logged in as administrator as
described in the previous paragraph. When that is done, you will find an new item in the tree on the
left side of the page, called ‘RFID > Signal’. Click on this item and on the right hand side of the page a
setting for the output power will appear.
ALARM SETTINGS
The alarm settings need to be set when the Eco Reader is used in combination with security gates.
The alarm functionality should be switched off, when the Eco Reader is used in combination with
other software, that is controlling the Eco Reader. Simultaneous use of alarm and other software will
affect performance in a negative manner.
Internal webpage
1. Go to the Settings > Alarm > Alarm page