User Manual

|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
26
a. Monitoring enabled: Enable\disable the AFI monitoring
b. IP Address: Enter the IP-address of the pc that is running
Bibliocheck4Monitor. Make sure the network is not blocking any communication
between the Eco Reader and this pc.
c. Port Enter the port which should be used for
communication
d. Monitoring mode: Specify here if only the ‘UID’ or ‘UID+Data’ should
be read from an alarming RFID tag.
e. Start address + Data length: Specify the start address and length of the data inside
the RFID tag, that should be read.
6. Use the mux page to select the internal 2x channel multiplexer, or an external combination
of multiplexers.
7.
a. External mux: select if an external mux is connected. If it is, use RF1 port to
connect the multiplexer to. RF2, RF3 & RF4 is disabled. When ‘External mux’ is
disabled, the internal multiplexer is enabled, depending on the number of Antennas.
b. Antennas Set the amount of antennas that are connected. For the
internal mux the maximum is 4.
LIBRIX ONLINE
When the Eco Reader should communicate with librixonline.com, it should have a registered
ReaderID. This ReaderID can be generated on the librixonline.com website, and should be copied to
the Eco Reader.
1. Go to Settings > Librix Online > Authorization
2. Enter the reader id in the field ‘ReaderID’