User Manual

|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
34
is used, the optimal cable length can be determined manually, by performing the following steps:
1. Install the antenna gates and all wires (coaxial, data cables) as usual, but make sure that you
at least have an excess coaxial cable length of 7m.
2. Strip the coaxial cable, and manually insert it into your measuring device.
3. Measure the resistance and reactance. If the resistance is >180Ω and reactance is
approaching j0Ω, you’re cable length is fine, and go to step 6.
4. If the resistance if very low, cut off a piece of the coaxial cable (~10cm)
5. Go to step 2 and keep cutting the cable until you have reached the right cable length.
When you have determined the right cable length, connect a BNC connector to the cable, roll-up the
excess cable length, and mount it near the Eco Reader.