User Manual

ManualsBrandsNederlandsche Apparatenfabriek NEDAP ManualsElectronicsInductive RFID card Reader operating on 13.56 MHz

|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||

PRECAUTIONS

 Installation of these products should be performed by a qualified installation partner.

 Do not use the product in damp places.

 If you smell smoke or other odors or hear a strange sound, unplug the power cord and

contact your dealer.

 Make sure to connect the power cable to a properly earthed outlet.

 Protect the power cord from physical or mechanical abuse, such as being twisted, kinked,

pinched, closed in a door, or walked upon. Pay particular attention to plugs, wall outlets, and

the point where the cord exits the Eco Reader.

 Do not disassemble, repair or modify the product at your own discretion.

 To reduce the risk of electrical shock or damage, do not expose this device to rain or

moisture.

 Refer all servicing to qualified service personnel. Servicing is required when the system has

been damaged in any way, such as power supply cord or plug is damaged, liquid has been

spilled, or the device has been dropped.

When your Eco Reader is of version REV.A (which can be seen on top of the PCB), and/or it

has a warning sticker next to the BNC connectors, do not connect an unterminated coaxial

cable to one of its RF outputs! This may permanently damage the Eco Reader. To be sure,

turn off power before you do any work or maintenance on the Eco Reader.

FCC ID: CGDECO41356 IC: 1444A-ECO41356

Compliance statements (part15.19)

This device complies with part 15 of the FCC Rules and to RSS210 of Industry Canada.

Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause

undesired operation.

Cet appareil se conforme aux normes RSS210 exemptés de license du Industry Canada.

L'opération est soumis aux deux conditions suivantes:

(1) cet appareil ne doit causer aucune interférence, et

(2) cet appareil doit accepter n'importe quelle interférence, y inclus interférence qui peut

causer une opération non pas voulu de cet appareil.

Warning (part15.21)

Changes or modifications not expressly approved by party responsible for compliance could

void the user’s authority to operate the equipment.